Evolution FURY3-S Instructions Originales page 28

Fig. 37
Fig. 38
Fig. 39
Fig. 40
Note: Blade Bore Reducing Inserts should only be used
in accordance with the manufacturers instructions.
wARNiNG: The arbor screw has a LH thread. Turn clockwise to
loosen. Turn counterclockwise to tighten.
Press & keep pressing the arbor lock button on the motor housing
while turning the arbor screw using the supplied Hex Key until the
button locates fully into the shaft and locks the shaft (Fig. 37) and
continue to remove the arbor screw, washer and outer blade
flange. (Fig. 38)
Release the arbor lock button.
• Ensure that the blade and blade flanges are clean and free
from any contamination.
• The inner-blade flange should be left in place but if it is removed
for cleaning it must be replaced the same way round as it was
removed from the machine.
To insert the blade Press the Lower Blade Guard Release Trigger
(A) rotate the lower blade guard (B) up into the upper blade
guard and hold the lower blade guard in that position. (Fig. 39)
Install the new blade onto the inner flange ensuring it is seated
properly on the flange shoulder and then slowly release the lower
blade guard back to its original closed position. Make sure the
rotation arrow on the blade (A) matches the clockwise rotation
arrow on the upper guard (B). (Fig. 40)
Note: The blade teeth should always point downward at the
front of the saw.
install the outer flange (1) (flat face onto the machine),
washer (2) and arbor screw (3). (Fig. 41)
Press & keep pressing the arbor lock button on the motor housing
while tightening the arbor screw using the supplied Hex Key until
the button locates fully into the shaft and locks the shaft. (Fig. 37)
Tighten the arbor screw using moderate force, but do not
overtighten. Ensure the Hex Key is removed and the arbor lock
button has released before operating. Ensure the blade guard is
fully functional before using the machine.
28
www.evolutionpowertools.com