Adjustment Of Precision Angles - Evolution F210CMS Instructions D'origine

www.evolutionpowertools.com
(8.3)
BODY AND HAND POSITIONING (Fig. 7)
• Never place your hands within the 'No Hands Zone'
(at least 150mm away from the blade). Keep hands
away from the path of the blade.
• Secure the workpiece firmly to the table and against
the fence to prevent any movement.
• Use a top hold down clamp if possible but check that it is
so positioned that it does not interfere with the path
of the blade or other moving machine parts.
• Avoid awkward operations and hand positions where a sudden
slip could cause your fingers or a hand to move into the blade.
• Before attempting a cut, make a 'dry run' with the power
off so that you can see the path of the blade.
• Keep your hands in position until the ON/OFF trigger switch
has been released and the blade has completely stopped.
(8.4)

ADJUSTMENT OF PRECISION ANGLES

Several checks/adjustments are possible on this machine.
The operator will require a 45°/45°/90° set square (not
supplied) to carry out these checks and adjustments.
WARNING: Checks/adjustments must only be conducted
with the machine disconnected from the power supply.
BEVEL ANGLES (0° & 45°)
0° Bevel Stop Adjustment
• Ensure that the cutting head is in the locked down position
with the latching pin fully engaged in its socket (see Fig.16).
• Ensure that the cutting head is upright, against its stop
and the bevel pointer is indicating 0° on the scale (Fig. 8).
• Place the set square on the table with one short edge
against the table and the other short edge against the blade
(avoiding the TCT tips of the blade teeth) (Fig. 9).
• If the blade is not at 90° (square) with the mitre table,
adjustment is required.
• Loosen the bevel locking handle and tilt the cutting head
to the left.
• Loosen the locknut on the bevel angle adjustment screw with
a 10mm spanner and 3mm Hex key (Not supplied) (Fig. 10).
• Use the Hex key to turn the screw in or out to adjust the
blade angle.
• Return the cutting head to its upright position and
recheck the angular alignment against the set square.
• Repeat the above steps until correct angular alignment
is achieved.
• Tighten the bevel angle adjustment locknut securely.
Fig. 7
Fig. 8
Fig. 9
Fig. 10
13
No Hand
Zone
No-Hands Zone No-Hands Zone
No-Hands Zone
EN