Evolution FURY3-S Instructions Originales page 26

Fig. 33
Fig. 34
Fig. 35
The Cutting Head can be tilted from the normal 0°
(perpendicular position) to a maximum angle of 45° from the
perpendicular to the left hand side only. Bevel cutting is possible
with or without the sliding carriage system being deployed.
To tilt the Cutting head to the left:
• Loosen the bevel lock lever. (Fig. 33)
• Tilt the Cutting Head to the required angle. A protractor
scale is provided as an aid to setting. (Fig 34)
• Tighten the bevel lock lever when the desired angle has
been selected.
Note: The bevel lock lever is sprung loaded and this enables
it to be repositioned on its operating screw. Repositioning
may be necessary to avoid interference with other parts of the
machine when certain mitre angles are selected.
To reposition the lever:
• Pull the lever outwards and turn to a convenient position.
• Release the lever.
STANCE
Stand to the left side of the handle when making a cut.
when cutting is completed:
• Release the ON/OFF trigger switch, but keep your hands
in position and allow the blade to completely stop.
• Allow the Cutting Head has to rise to its upper position,
with the lower blade guard completely deployed before
removing yours hand(s).
• Return the Cutting Head to the perpendicular position.
COMpOUND CUTTiNG
(8.7)
A compound cut is a combination of a mitre and bevel cut
employed simultaneously.
When a compound cut is required, select the desired bevel and
mitre positions as previously described.
Compound cutting with the sliding carriage system deployed is
possible. Always check that the sliding blade does not interfere
with the machines fence or any other parts of the machine.
Adjust the upper left hand section of the fence if necessary.
26
www.evolutionpowertools.com
(Fig. 35)