Evolution FURY3-S Instructions Originales page 16

Fig. 8
Fig. 9
• Projected Laser Beam is not parallel with the indentations
= Follow section A.
• Beam is parallel with but not aligned to the indentations
= proceed to B.
Section A.
• Loosen the clamping screw. (Fig. 8)
• Carefully and gently rotate the laser module, until the line is
parallel with the marks in the cardboard.
• Re-tighten the clamping screw.
• Recheck the alignment.
Section B.
Laser beam parallel with the indentations, but not going
through them:
• Slacken the two hex screws. (Fig. 9)
• The laser mounting block can now be moved sideways to align
the laser beam with the indentations made in the cardboard.
• When the laser beam is in the correct place, re-tighten the
two screws.
• Repeat procedure 'A' to check alignment.
Note: The above adjustments & alignments should be checked
on a regular basis to ensure laser accuracy.
Note: The following wARNiNG labels may be found on
this machine:
LASER RADiATiON
DO NOT STARE iNTO ThE BEAM
CLASS 2 LASER pRODUCT
Never look into the laser beam. Direct laser beam may
injure your eyes.
16
www.evolutionpowertools.com