Close Call Delay - Albrecht AE125H Mode D'emploi

You can also store these temporary frequencies into channel storage
banks when you receive them in Scan mode and scroll to them in Scan
Hold mode. See also Storing Found Search Frequencies on page 102.

Close Call Delay

This setting controls how long the scanner stays on the frequency after a
transmission ends before resuming Close Call operation. If you select a
minus delay time, the scanner stops on the transmission for the preset
time and then automatically resumes searching. (Default = 2
seconds).This setting affects both Search and Close Call.
1. Press Func then Hold to view the Close Call menu.
2. Scroll to Set Delay and press Pgm/E.
3. Scroll to select the delay time from following options:
• -10 sec - resumes after 10 seconds.
• - 5 sec - resumes after 5 seconds.
•
0 sec - resumes immediately.
•
1 sec - waits 1 second for a reply then resumes.
•
2 sec - waits 2 seconds for a reply then resumes.
•
3 sec - waits 3 seconds for a reply then resumes.
•
4 sec - waits 4 seconds for a reply then resumes.
•
5 sec - waits 5 seconds for a reply then resumes.
4. Press Pgm/E to save and return to the Close Call menu.
Close Call CTCSS/DCS Search
This setting controls whether the scanner will search for a subaudible
tone when it stops on a transmission during Close Call operation.
(Default = On).This setting affects both Search and Close Call.
3. Press Func then Hold to view the Close Call menu.
4. Scroll to CTCSS/DCS Search and press Pgm/E.
5. Scroll to select one of the following options:
• Search Off
• Search On
5.
Press Pgm/E to save and return to the Close Call menu.
English 109