Setting Step Frequency; Setting Modulation - Albrecht AE125H Mode D'emploi

Setting Step Frequency

You can change the steps of each band. Selected step affects both
search and Close Call.
For air band, selected step also affects air service search.
1. Press Func then 3/Step to step frequency menu while
holding the frequency.
2. The scanner displays the current steps.
3. Turn SCROLL CONTROL to select steps from Default,
5kHz, 6.25kHz, 10kHz and 12.5kHz. (for air band, 8.33kHz
or 12.5kHz) (for 84.015 - 88 MHz band, 20kHz step is
added)
4. Press Pgm/E to select and then return previous mode. Also,
you can set Step Frequency by Search Menu.
Note: If the scanner is turned off, step frequency is set to initial setting.

Setting Modulation

You can change the modulations of each band. Selected modulation
affects both search and Close Call.
For CB band and HAM band, selected modulation also affects CB band
and HAM band service search.
For Air band, the modulation is AM only.
1. Press Func then 9/Mod to change the modulation while
holding the frequency.
2. The scanner displays the modulation for 1 seconds.
3. Then return previous mode.
Also, you can set Modulation by Search Menu.
Note: If the scanner is turned off, modulation is set to initial setting
except CB band and HAM band.
104 English