Programming Channel Text Tags; Setting Ctcss/Dcs For A Channel - Albrecht AE125H Mode D'emploi

Note: The scanner first checks the Bank in which you want to store the
channel. If the scanner does not find a duplicated channel in that Bank
then the scanner will check further the remaining Banks of your scanner.
When the scanner would find a duplicate in any of the Banks the channel
number and a message to confirm the duplicated frequency are shown.
If you entered the frequency by mistake, press .Clr then enter the correct
frequency. To enter the frequency anyway, press Pgm/E to accept.

Programming Channel Text Tags

You can customize your channels by programming text tags (up to 16
characters in length) for easier channel frequency identification. The
default tag is the bank number followed by the channel number in the
bank.
1. To select a channel, press Hold and then enter the channel
number.
2. Press Pgm/E to enter the Channel menu. (You can also
press Hold and scroll to the channel; press Func then
Pgm/E.)
3. Scroll to select Edit Tag and press Pgm/E.
4. Turn SCROLL CONTROL to choose the characters, pressing
> or < to move the cursor to the right or left. If you make a
mistake, press .Clr to clear the last character. Press .Clr
twice to clear all characters. To cancel and exit, press L/O.
5. Press Pgm/E to save the tag and return to the Channel
menu.

Setting CTCSS/DCS for a Channel

You can store a CTCSS tone or DCS code, set the scanner to search for
tones/codes, have the scanner open squelch on any tone/code, or have
the squelch only open if no CTCSS/DCS is detected for any channel.
(Default = Off )
1. To select a channel, press Hold and then enter the channel
number.
2. Press Pgm/E to enter the Channel menu. (You can also
press HOLD and scroll to the channel; press Func then
Pgm/E.)
90 English