Set Close Call Bands - Albrecht AE125H Mode D'emploi

The modulation and any CTCSS/DCS received (if enabled) will also
appear on the display.
Numbers at the bottom of the display show the enabled Close
Call bands. The currently searched band number flashes.
When the transmission ends, the scanner resumes searching according
to the delay setting.
To hold on a frequency, press Hold.
To start a Quick Search at the current frequency, turn the SCROLL
CONTROL in Hold mode and press Hold to start searching.
To resume searching, turn the SCROLL CONTROL.
To temporarily lock out a frequency, press L/O.
To permanently lock out a frequency, press L/O twice quickly.
To store a frequency, press Pgm/E. See Storing Found Search
Frequencies on page 102.
To exit Close Call Only mode, press Scan.
The following paragraphs describe Delay, CTCSS/DCS, Alert Settings,
Setting Close Call Bands, and reviewing/unlocking frequencies.

Set Close Call Bands

This setting allows you to select the bands searched for all Close Call
modes.
1. Press Func then Hold to view the Close Call menu.
2. Scroll to Close Call Bands and press Pgm/E.
3. Scroll to each band you want to enable/disable and press
Pgm/E.
4. Scroll to select C-Call Band On or Off and press Pgm/E.
•
25- 88 VHF-Low - VHF Low Band (25 - 88 MHz)
• 108-137 Aircraft – Aircraft Band (108 - 137 MHz)
• 137-174 VHF-Hi1 - VHF High 1 Band (137 - 174 MHz)
English 107