Installing Non-Rechargeable Batteries; Installing Rechargeable Ni-Mh Batteries - Albrecht AE125H Mode D'emploi

CAUTIONS:
•
When
every 15 seconds, recharge or replace the batteries.
•
Use only fresh batteries of the required size and
recommended type.
•
Always remove old or weak batteries. Batteries can leak
chemicals that destroy electronic circuits.
•
Do not mix old and new batteries, different types of batteries
(standard, alkaline, or rechargeable), or rechargeable batteries
of different capacities.
•
Do not use and charge Ni-Cd batteries; this may cause a
safety hazard and damage the scanner.

Installing Non-Rechargeable Batteries

1. Make sure the power is turned off.
2. Slide the battery compartment cover off.
3. Use a pointed object such as a ballpoint pen to set the battery
selection switch inside the compartment to ALK.
4. Insert the batteries as indicated by the polarity symbols (+and
-) marked inside the battery compartment.
5. Replace the battery compartment cover.

Installing Rechargeable Ni-MH Batteries

You can also use two Ni-MH rechargeable batteries to power your
scanner. The Ni-MH batteries included with your unit are not fully
charged; you must charge them completely after you install them into
your scanner. See Charging the Ni-MH Batteries, page 78, for details.
1. Make sure the power is turned off.
2. Slide the battery compartment cover off.
3. Use a pointed object such as a ballpoint pen to set the battery
selection switch inside the compartment to Ni-MH for Nickel
Metal-Hydride batteries.
flashes in the display and the scanner beeps
English 77