1 / INSTALLING YOUR APPLIANCE
• •
GAS CONNECTION
•Preliminary comments
If your hob is installed above an oven or if proximity to other heating elements poses a threat of
overheating the connection, you absolutely must insulate the cable in a rigid pipe.
If a hose or soft pipe (in the case of butane gas) is used, it should not come into contact with a
moving part of the cabinet, nor should it pass through a location that may become blocked.
The gas connection must be installed in com-
pliance with applicable regulations in the
country of installation.
• Gas distributed by pipe; natural
gas, propane-air gas or butane-air
gas
For your safety, you must choose from the
three following connection options:
— C C o o n n n n e e c c t t i i o o n n w w i i t t h h a a r r i i g g i i d d p p i i p p e e made from cop-
per and with screw-on mechanical connec-
tors (G1/2 gas standard mark). Make the con-
nection directly to the end of the elbow fitted
on the appliance.
— C C o o n n n n e e c c t t i i o o n n w w i i t t h h a a f f l l e e x x i i b b l l e e m m e e t t a a l l h h o o s s e e (stain-
less steel) w w i i t t h h s s c c r r e e w w - - o o n n m m e e c c h h a a n n i i c c a a l l c c o o n n n n e e c c - -
t t o o r r s s (compliant with NF D 36-121 standard)
whose service life is unlimited (Fig. A).
— C C o o n n n n e e c c t t i i o o n n w w i i t t h h a a f f l l e e x x i i b b l l e e rubber h h o o s s e e rein-
forced w w i i t t h h s s c c r r e e w w - - o o n n m m e e c c h h a a n n i i c c a a l l c c o o n n n n e e c c t t o o r r s s
(compliant with the NF D 36-103 standard)
whose service life is 10 years (Fig. B).
Warning
When connecting your hob's gas sup-
ply, if you have to change the direction of
the elbow fitted on the appliance:
① ① Change the gasket.
② ② Screw on the elbow's nut, careful not to
exceed a torque of 17 N.m.
Q
@
Q
@
Fig. A
29
Fig. B