Using The Motor; Stowing & Deploying - MINN KOTA POWERDRIVE V2 Manuel De L'utilisateur

USING & ADJUSTING THE MOTOR
STOWING AND DEPLOYING THE MOTOR
WARNING:
When raising or lowering the motor, keep fi ngers clear of all hinge and pivot points and all moving parts.
DEPLOY-ASSIST LEVER OPERATION:
1. Loosen the depth collar screw.
2. Push Deploy-Assist Lever down.
3. Push motor out.
4. Tighten the depth collar screw.
Depth Collar Deploy-Assist Lever
Tilt Lock Lever
TO DEPLOY THE MOTOR
Loosen the Dept Collar screw, then push fi rmly down on the Deploy-Assist Lever to release the collar and slide the motor
forward, out from the ramp. Lower the motor to the desired depth. Make sure it clicks into a secure, vertical position.
TO STOW THE MOTOR
Push down on the Tilt Lock Lever and raise the motor by pulling up on the composite shaft or control head. Pull the motor toward
the stern until it rests securely on the ramp and the Deploy-Assist Lever captures the latch collar. Slide the depth collar down and
secure it against the top of the steering housing to secure the motor in place and prevent accidental deployment.
TRANSPORTATION
In conditions where the stowed motor is subject to high levels of shock or vibration, take care to provide a secure stow. Move the
depth collar snug against the steering motor and tighten.
TO ADJUST THE LATCH COLLAR
The latch collar is adjustable. If needed, loosen the Phillips head screw and rotate the collar up or down to re-align the latch and
collar. The ideal adjustment is a slightly loose fi t that completely captures the collar.
10 | minnkotamotors.com
2
3
Latch Collar
Latch Collar
©2015 Johnson Outdoors Marine Electronics, Inc.