Using The Motor; Stowing & Deploying - MINN KOTA RIPTIDE TERROVA Mode D'emploi

USING & ADJUSTING THE MOTOR
STOWING AND DEPLOYING THE MOTOR
WARNING:
When raising or lowering the motor, keep fingers clear of all hinge and pivot points and all moving parts.
STOW/DEPLOY LEVER OPERATION:
1. Push in
2. Push down
1
2
GENERAL
System Ready (green LED): The motor is equipped with a system ready indicator. Indicator light will be on when motor is
deployed and power is applied to the motor. When the motor is properly stowed the indicator light will go off indicating all power
has been turned off to the motor. If this indicator light does not come on when deployed, check that motor is connected to battery
properly and motor is completely deployed. If indicator light does not go off when stowed, be sure that stow/deploy lever is fully
latched and locked into the stowed position.
TO DEPLOY THE MOTOR
Push in and rotate the stow/deploy lever down. Gently slide the motor out from the ramps. Lower the motor to the desired depth,
making sure that it clicks into a secure, verticle position. The System Ready indicator light (green) will be lit, indicating motor is
ready for operation.
TO STOW THE MOTOR
Push and hold the stow/deploy lever down. Gently tilt and pull the composite shaft or control head until the motor engages the
motor ramps. Motor should rest on the motor ramps and lock into place. The stow/deploy lever should latch automatically into the
stowed position. The system ready indicator light (green) MUST go off for the motor to be stowed properly.
TRANSPORTATION
In conditions where the stowed motor is subject to high levels of shock or vibration, ensure the motor is securely stowed. Move
the depth collar snug against the steering motor and tighten.
©2015 Johnson Outdoors Marine Electronics, Inc.
Depth Collar
Stow/Deploy System Ready
Lever Indicator
Steering Housing
Fall Away Ramps
minnkotamotors.com | 11