Mounting The Manual Unlocking V60 - GILGEN ASL-S Instructions D'installation Et D'utilisation

2.6.2 Mounting the manual unlocking mechanism V60
- This option is used in cases where the red button on the sliding carriage(100) in the chain drive system (23) is not
easily accessible (e.g. because it is too high).
21
- Determine the position of the actuation lever in such a manner that
• it is easily accessible
• the Bowden cable necessary for the connection to the uncoupling mechanism is as short as possible.
- Screw the actuation lever (51) onto the door, using the supplied fixing material. Fig. 34
- Pull the steel cable (54) through the hole drilled into the sliding carriage (100) and into the guide piece (101). Grip
the cable end and mount the screw nipple (57).
- Pull back the steel cable (54) until the red button (102) moves.
- Mount the angle (103) with the drilled screw (55) and the cable guideway (104).
- Lead the steel cable (54) through the drilled screw (55) and the Bowden cable sheathing (52) along the drawbar
(105) up to the actuation lever (51). Fig. 34/35/36
- Lay out the Bowden cable (52) straight to the drilled screw (55) without bending the cable. Fig. 36
- Push the steel cable (54) through the Bowden cable sheathing (52) up to the drilled screw (55) and the axle (59).
23
0602-999-11c_2008.09.p65
57
100 101 102
0602-999/11c
ASL-S
23-40
23 100
54
104 103 55 52 105
52 51
A
Fig. 34
Fig. 35