American Standard Advanced Clean 100 Serie Manuel De L'utilisateur page 59

Troubleshooting
Other
Symptom
There are water
drops on the
bottom of the
®
SpaLet and the
bottom of the
water shutoff
valve.
There are water
drops on the
underside of the
SpaLet seat.
A gurgling sound
comes from the
SpaLet seat
● Power plug is
connected to
an outlet
● Nozzle spray
has stopped
A hissing sound
is coming from
the SpaLet.
The power
indicator is
flashing.
Cause
Condensation has formed due to
high humidity.
Water drops from the nozzle
spray land on the underside of the
SpaLet seat.
This is not a malfunction.
This is the sound of the motor operating during normal nozzle spray
SpaLet operation. If the water pressure and nozzle position can be
adjusted properly, then there is no problem.
This is the sound of the plasmacluster ion generator. It is not a
malfunction. The type of sound may vary. The sound may appear quieter
or louder depending on the usage environment. This has no bearing on
the plasmacluster ion effect.
Water supply is not connected to
the SpaLet due to a suspended
water supply or closed water
shutoff valve.
Several functions are
malfunctioning.
An anti-freezing heater is attached
to the water supply hose or other
pipe.
Solution
Frequently wipe the water drops.
Also make sure that there is
sufficient ventilation.
Frequently wipe the water drops.
Additionally, sitting further back
on the seat when using the nozzle
spray will lessen splashing.
After restoring the water supply,
open the water shutoff valve and
test operation.
If the the power LED is still flashing,
then disconnect the power plug
and have the SpaLet serviced.
If the power LED flashes after
the power has been turned off,
this indicates that the SpaLet is
damaged. Disconnect the power
plug from the outlet and have the
SpaLet serviced.
Turn off the anti-freezing heater.
When the water temperature
exceeds 40°C/104°F, the safety
system in this product stops
operation.
Page
ー
ー
ー
ー
7
ー
ー
56 - EN