American Standard Advanced Clean 100 Serie Manuel De L'utilisateur page 50

Troubleshooting
Rear Washing, Rear Washing - Mild, and Front Washing
Symptom
Nozzle spray
does not
discharge.
It takes longer
than usual for the
nozzle spray to
discharge.
The preparation
time before the
nozzle spray
discharges may
be longer than
models you have
used in the past.
47 - EN
Cause
Water shutoff valve is closed.
The strainer is clogged.
The water pressure is low. Water
pressure is set to the lowest
setting.
Seat sensor is not triggering.
The temperature of the water
supplied to the SpaLet is too high.
The SpaLet is flushing.
The water temperature is not set to
an appropriate temperature.
When purchasing a replacement model, the preparation time before
the shower spray discharges may be longer due to changes in product
design.
This is a feature of the product and is not a malfunction.
Solution
Turn the open/close knob 180°
counterclockwise.
Clean the strainer.
Press the 【＋】 side of the [SPRAY
STRENGTH] button.
®
Sit on the SpaLet .
This is not a malfunction. When
the water temperature exceeds
40°C/104°F due to anti-freezing pipe
heaters or similar, the nozzle spray
does not discharge until hot water
is removed from the pipe. In this
scenario, drain the hot water from
the pipes by flushing the SpaLet
and then try pressing the button for
the desired washing function. If this
phenomenon occurs repeatedly,
then review the usage of the anti-
freezing pipe heater.
This is not a malfunction. The
SpaLet flushing process has priority.
Press the button for the desired
washing function after the SpaLet
finishes flushing.
This is not a malfunction. When
water temperature is low such as in
winter, it may take time to prepare
warm water before the nozzle spray
discharges.
Page
7
43
14
25
ー
14
ー
ー