Draining Water - American Standard Advanced Clean 100 Serie Manuel De L'utilisateur

Useful Information
Use the following procedure to drain the water and disconnect the power if the following circumstances are applicable.
● The SpaLet ® will not be used for an extended period of time due to travel. Long-term storage may cause water to
become contaminated. This contaminant could deposit on the SpaLet.
● The SpaLet will not be used for an extended period of time due to being in a vacation home. As temperatures drop in
unoccupied houses during the course of colder seasons, water could freeze during times of cold temperatures.

Draining Water

1 Close the water shutoff valve to shut off
the water supply.
* If the open/close knob is difficult to turn, grasp it
with a dry cloth and turn.
Water shutoff
valve
Open/close
knob
2 Press the 【Flush Full】 button or press the
flush button on the SpaLet body.
* Wait approximately 20 seconds.
* Confirm that the water does not flow when
attempting to flush the SpaLet.
3 Drain the water from the water supply
side.
① Remove the side cover on the left side when
facing the SpaLet body.
( ☞ Page 42)
② Place a basin or similar beneath the strainer.
③ Remove the strainer, rinse away dirt that has
attached to the strainer and O-ring, and then
completely remove the part.
②
①
Turn clockwise
Strainer
[CAUTION]
● When removing the strainer, make sure not to
damage the water supply hose.
④ Insert the power plug into an outlet.
29 - EN
⑤ Press and hold both the 【Power Save】 and
【Auto Clean】 buttons for at least 2 seconds.
* Remaining water in the SpaLet body will drain
over a 15-second period.
Close
【 Power Save 】 + 【 Auto Clean 】
⑥ Disconnect the power plug from the outlet.
⑦ After the water has been drained, securely
reattach the strainer.
4 Reinstall the side cover.
* Perform steps 1 through 3 of the "Installing Side
Covers" procedure to install the side cover.
( ☞ Page 42)
5 Check for leaks from the water shutoff valve.
①
②
Turn counterclockwise
Strainer