American Standard Advanced Clean 100 Serie Manuel De L'utilisateur page 44

Cleaning and Maintenance
Removing the Nozzle Shutter
1 Open the nozzle shutter ( ☞ Page 39)
* The nozzle extends to open the nozzle shutter.
2 Pull the nozzle shutter down toward you
with both hands to remove.
3 Clean the removed nozzle shutter.
● U se a soft, damp cloth to clean.
[CAUTION]
● Do not wipe parts with a dry cloth or toilet paper.
● Do not scrub with a toothbrush.
* Doing so may cause damage.
Assembling the Nozzle Shutter
1 Attach the two lugs of the nozzle shutter
into the slot in the shutter base from below.
* If the shutter base is closed, perform the procedure
described in the "Opening the Nozzle Shutter" section.
* Make sure the auto clean and auto seat open
functions are turned off before returning the nozzle
shutter to its original position.
Shutter base
Slot
Attach so that the triangle
mark faces forward.
2 Press the 【STOP】 button to return the
nozzle shutter to the original position.
[CAUTION]
● Press until it clicks into place.
Make sure the shutter is correctly installed.
● Installing the shutter in the incorrect vertical
orientation can cause malfunctions such as no
nozzle extension or no shutter opening.
● Do not apply excessive force.
* Doing so may damage the part.
41 - EN
Dust and dirt that has accumulated on the dust filter may
result in reduced deodorizing performance. Clean the
filter if odors are noticeable.
1 Open the nozzle shutter ( ☞ Page 39).
2 Remove the dust filter.
3 Wash the dust filter to remove dust
4 Allow the dust filter to dry and
[Enlarged View of the Lug]
Lug
5 Press the 【STOP】 button to return the
Cleaning Air Shield Filters
* The nozzle extends to open the nozzle shutter.
and dirt.
then reinstall.
nozzle shutter to the original position.
* Make sure the auto clean and auto seat open
functions are turned off before returning the nozzle
shutter to its original position.
®
■ Reusing the SpaLet
Always perform the necessary preparations and
checks before use. ( ☞ Page 7)
Dust filter