Cleaning and Maintenance
If long-term use of the SpaLet
spray, use the following procedure to clean the strainer. This should be performed roughly once every 2 years.
Cleaning the Strainer
1 Close the water shutoff valve to shut off
the water supply.
* If the open/close knob is difficult to turn, grasp it
with a dry cloth and turn.
Water shutoff
valve
Open/close
knob
2 Press the 【Flush Full】 Button or press the
flush button on the SpaLet body.
( ☞ Page 17)
* Wait approximately 20 seconds.
* Drain the water and remove the water pressure
inside the SpaLet body.
3 Remove the side cover on the left side
when facing the SpaLet body ( ☞ Page 42).
4 Turn and remove the strainer at the lower
left when facing the SpaLet body.
* Place a towel or similar underneath the strainer as
a small amount of water will spill when removing the
strainer.
②
①
Turn clockwise
Strainer
[CAUTION]
● When removing the strainer, make sure not to
damage the water supply hose.
43 - EN
®
has resulted in a weak flow of water when flushing the SpaLet or using the nozzle
Close
5 Wash away all debris inside the strainer
and from the O-ring.
O-ring
6 Fully tighten the strainer.
①
②
Turn counterclockwise
Strainer
[Mounting Precautions]
● Make sure the strainer assembly is reinstalled
properly after removing it for washing.
7 Reattach the side cover ( ☞ Page 42).
8 Fully open the water shutoff valve.
9 Check for leaks from the water shutoff
valve.
■ Reusing the SpaLet
Always perform the necessary preparations and
checks before use. ( ☞ Page 7)
CAUTION
● When removing the strainer,
make sure to close the water
shutoff valve and press the
OBSERVE
flush button.
● When installing the strainer, make
sure that the water shutoff valve
is tightened completely.
● Check that there is no debris
remaining on the O-ring before
installing the strainer.
* Check that the O-ring is free from foreign
materials as failure to do so may result in
water leakage and flooding.
Strainer