Adjust The Seat Temperature - American Standard Advanced Clean 100 Serie Manuel De L'utilisateur

Preparation and Checks Before Use
STEP Operate the Nozzle Spray
4
* The nozzle spray will not function while the SpaLet
SpaLet has finished flushing.
1 Roll up your sleeve and set your
arm on the SpaLet seat.
* The SpaLet is equipped with a seat sensor that detects
the presence of someone sitting on the SpaLet seat.
The nozzle spray and dryer will not function if the sensor
is not triggered.
* Allow the nozzle spray to operate for approximately 30
seconds to bleed air in the water line during initial use.
2 Press the 【 Cleansing (Full) 】 button.
* At this time, water will discharge from around the nozzle
as a preliminary operation.
3 Place a hand above the nozzle tip
to block the sprayed water.
4 Press the 【 STOP 】 button to stop
the nozzle spray.
STEP
5

Adjust the Seat Temperature

● Change the temperature
* Press the corresponding switch to change the
different temperatures.
Water Temp.
* There are 6 levels of water temperature available
including "Off", "Low (approximately 32°C/89.6°F)", "High
(approximately 40°C/104°F)", and the other levels between
low and high. Select your temperature preference in
accordance with the season.
Seat Temp.
* There are 6 levels of seat temperature available
including "Off", "Low (approximately 28°C/82.4°F)", "High
(approximately (36°C/96.8°F)", and the other levels between
low and high. Select your temperature preference in
accordance with the season.
Dryer Temp.
* There are 3 levels of drying temperature available including
"Low", "Medium", and "High". ( ☞ Page 16)
9 - EN
®
is flushing. Operate the nozzle spray after the
Water Temp. Indicator
Seat Temp. Indicator
Dryer Temp. Indicator