American Standard Advanced Clean 100 Serie Manuel De L'utilisateur page 53

Troubleshooting
Deodorizer
Symptom
The Air Shield
Fan Keeps
Running
The Air Shield fan
does not operate.
The Air Shield
effect has
weakened (odors
are noticeable).
SpaLet flushing
Symptom
The SpaLet
does not flush
automatically.
Water flow is
poor or the
SpaLet does not
completely flush.
Water flow is
poor or the
SpaLet does not
completely flush.
Cause
The seat sensor is wet or dirty.
The bowl cleaning function is not
operating.
The automatic Air Shield function is
turned off.
The seat sensor is wet or dirty.
The seat has been used for over
an hour.
Dirt is present on the Air Shield
filter.
The SpaLet has not been used for
a long period of time.
Cause
The full auto flushing function is
turned off.
The water shutoff valve is not fully
open.
The strainer is clogged.
The water supply hose is bent.
Do not flush large quantities of
toilet paper.
Solution
The seat sensor may make false
detections. Clean the SpaLet
This is not a malfunction.
The bowl cleaning function operates
intermittently in cycles of 45 minutes
of operation and 15 minutes of
no operation. The Air Shield fan
operates for one minute after the
user stands up from the SpaLet.
Turn on the Air Shield.
The seat sensor may make false
detections. The Air Shield fan turns
off automatically when a detection
triggered state lasts for at least 2
hours. Clean the SpaLet seat or try
standing up from the seat and sitting
back down again.
Clean the Air Shield filter.
The SpaLet is equipped with a part
that absorbs odors. Have this part
replaced.
Solution
Turn on the full auto flushing
function.
Fully open the water shutoff valve.
Clean the strainer.
Failures can be easily corrected
in some cases. Please check the
following items.
Toilet paper does not completely
flush when a partial flush is used.
Use a full flush instead.
A full flush corresponds to
approximately 5 m/16-1/2 ft.
of toilet paper.
Page
ー
®
seat.
19
23
ー
41
ー
Page
17
7
43
ー
17
5
50 - EN