American Standard Advanced Clean 100 Serie Manuel De L'utilisateur page 60

Troubleshooting
Other (Continued)
Symptom
● There is play in
®
the SpaLet seat.
● One of the feet
on the back
side of the
SpaLet seat
is not making
contact with the
SpaLet bowl.
There is a gap
between the
SpaLet body and
ceramic portion.
Water is leaking
Reset all settings
back to the
default settings.
Using the SpaLet
causes the room
lighting to flicker.
The nozzle
shutter does not
close.
The SpaLet bowl
is illuminated in
blue.
The occupied
seat mode was
interrupted and
reset.
57 - EN
Cause
This is not a malfunction.
The construction of the SpaLet seat is different at the top and bottom
sections. For this reason, there are gaps between the SpaLet seat feet
and the SpaLet bowl.
This SpaLet seat is designed so that only one front foot makes contact
with the SpaLet bowl. Therefore, the SpaLet can continue to be used.
This is not a malfunction.
A gap may be visible due to the individual differences of fired ceramic
products.
Please continue use.
The strainer is loose.
There is debris on the strainer.
The temperature is too high.
Condensation is forming.
Reset all settings changed using
the procedures described in the
"Useful Functions" section to the
default settings.
This is not a malfunction.
This can happen due to the temporary increase in power consumed to
heat the water for the shower spray. Please continue use.
This is not a malfunction.
The nozzle shutter opens while the air shield deodorizer, bowl cleansing,
and room refresh functions are operating. Turn off settings as necessary.
This is normal and not an issue.
The occupied seat mode may be interrupted and reset as the result of
electromagnetic environment.
Solution
Tighten the strainer.
Clean the strainer.
Frequently wipe the water drops.
Also make sure that there is
sufficient ventilation.
Perform the procedure to reset
settings to default settings.
If you prefer this feature off, turn off
the blue light setting.
Page
ー
ー
43
43
ー
24
ー
ー
23
ー