General Operation; Air Shield Function - American Standard Advanced Clean 100 Serie Manuel De L'utilisateur

General Operation

Standing in front of the SpaLet
STEP
1
automatically opens the
SpaLet lid
* This is turned on by default.
* If the seat sensor does not trigger after the SpaLet
lid opens independently, the SpaLet lid closes
automatically after approximately 3 minutes.
* The upper body sensor detects changes in heat (person's
movement) and automatically opens the SpaLet lid.
Leaving the SpaLet lid open may cause the SpaLet to
detect people passing in front of the SpaLet.
* The SpaLet lid will not open automatically for
approximately 1 minute after plugging the power plug
into an outlet. This is to prevent sudden operation due to incorrect sensor detection.
* The SpaLet lid will not open for 10 seconds after having been closed manually.
Using the remote control to open and
close the SpaLet seat
Press the 【 Open/Close 】 button.
* The SpaLet seat will open or close each time the 【Open/
Close】 button is pressed.
(Reference)
● If the room temperature exceeds 30°C/86°F, such as
in summer, the sensor may have difficulty detecting
people. Make sure that there is adequate ventilation
in the bathroom, or try moving your body.
● Auto Seat Open can be turned off. ( ☞ Page 23)
* Turn off 【Auto Seat Open】 before allowing small
children to use the SpaLet. In very rare occasions,
the seat sensor may not trigger causing the
SpaLet lit to close during use.
● This SpaLet is equipped with a function to open both
the SpaLet seat and SpaLet lid together at the same
time. ( ☞ Page 23)
STEP
2

Air Shield Function

1 The deodorizing process starts when a user sits
down on the SpaLet.
The deodorizer fan activates to clear odor from inside the SpaLet bowl.
2 The deodorizing process stops once a user stands up.
The deodorizer fan stops automatically 1 minute after standing up.
(Reference)
● The automatic deodorizing function can be turned off. ( ☞ Page 23)
13 - EN
®
bowl
[CAUTION]
● If direct sunlight reaches the sensor, or heaters or lighting
equipment that emit strong heat are installed in the
bathroom, the sensor may detect incorrectly due to the
heat, and the SpaLet lid may open automatically. Make
sure that direct sunlight does not reach the sensor, or try
changing the orientation of heaters or lighting equipment.
● Gently move the SpaLet lid without applying excessive
force to open or close it manually.
* Applying excessive force may cause damage.
● Using unsuitable cloth covers may cause the SpaLet seat
or SpaLet lid not to open automatically or some other
malfunction.