American Standard Advanced Clean 100 Serie Manuel De L'utilisateur page 30

Useful Information
Water Discharges from a Point
Near the Nozzle Tip
Water discharges from a
point near the nozzle tip
immediately after a user
sits down on the SpaLet
as well as before and after
washing. This is required
for the function and is not
indicative of a failure.
Warm Air has an Odor When
the SpaLet is Used Initially.
Warm air may have a slight odor when the SpaLet is
new. This is not indicative of a malfunction.
This odor will disappear as the SpaLet is used.
Energy Conservation.
● Close the SpaLet lid after use.
● Install a SpaLet seat cover.
● Do not set the temperature of the SpaLet seat or
warm water too high.
● Frequently adjust the temperature settings in
accordance with the season.
● Use the power save functions whenever possible if
available.
● Always turn off the power if you will be gone for
extended periods of time.
* Keep SpaLet seat covers clean.
* If there is any possibility of water freezing, do not
disconnect the power plug from the outlet as the
power must remain turned on. Refer to "If the Water
in the Tank is Frozen" for more information.
( ☞ Page 30)
Radio or Television Interference.
Interference may occur
if a television or radio is
located near the SpaLet.
In such cases, move the
radio or television as far
away from the SpaLet as
necessary to remove the
interference.
27 - EN
®
Suitable Cleansers
Use a neutral cleanser suitable for plastics to clean
plastic parts such as the SpaLet seat and lid.
Do not use chlorinated cleansers, acidic cleansers, or
disinfectants to clean the SpaLet bowl or other areas
of ceramic material.
Formation of Condensation.
Due to differences in humidity or temperature of the
room and SpaLet bowl, SpaLet surface, or water
shutoff valve, water droplets (condensation) may
form on the surface of these parts. Ensure adequate
ventilation to prevent condensation. Use a dry cloth to
wipe any droplets that have formed.
* Condensation may stain or damage the floor.
* This SpaLet is designed to be resistant to
condensation. However, condensation can form
depending on the room temperature and other
conditions.
Odors During Flushing.
If there is insufficient ventilation odor may temporarily
occur when flushing the SpaLet. Make sure to provide
adequate ventilation.
Side of SpaLet Seat is Cold.
The heating function of
the SpaLet seat primarily
functions to heat the top
surface, so the side may
feel cold to the touch.
Side is Cold