Mounting Of The Control Unit; Removal Of The Front Lid; Surface Mounting - Sentiotec IS1 Instructions De Montage Et Mode D'emploi

5

Mounting of the control unit

Caution - damage to the device: Do not use a cordless screwdriver to mount the control unit.

5.1 Removal of the front lid

In order to mount the control unit to the wall, the front
cover of the control unit must be removed. To this end,
use a fl at screwdriver with a breadth of approx. 3mm.
• Guide the screwdriver into the intended opening on
the underside of the control
• The lid is held on by a snap-on hook.
• Press this carefully inwards until the lid becomes detached.
• Now remove the lid from the control unit.
After the operating element is attached to the wall,
the lid must be replaced.
• First of all, mount the lid on its upper edge into the control unit housing.
• Now press the underside against the housing until the lid locks into place again.

5.2 Surface mounting

Use the long screws contained in the scope of supply to mount the
control unit. Do not use a larger diameter under any circumstances.
This can cause irreparable damage to the housing.
When inserting the screws, ensure no damage
is caused to any cables installed in the wall.
This can cause serious injury to people and
serious damage to property.
WE DO IT FIRST.
Instructions for installation and use – only for experts
Fig 6 Remove lid
Fig. 7 Surface mounting
P. 7/14
EN