Air Filter; Replace Engine Coolant; Recommended Lubricants; Maintenance Of The Trailer - Dibo JMB-C+ Mode D'emploi

6.2.10. Air filter
The air filter is mounted beneath the radiator of the diesel engine. A vacuum detector is mounted on the back
side of this filter and gives a signal when the air filter is polluted. At pollution an indication goes on at the
control panel. After the going on of the indication light, the air filter must be cleaned or replaced as soon as
possible. It's also recommended to check or replace the air filter as described at the maintenance diagram
and the motor specifications. At the switching on of the machine the filter state is checked automatically and
the indication extinguish as soon as the filter is clean or replaced.

6.2.11. Replace engine coolant

You can find the coolant reservoir on top of the engine (see photo). Recommended coolant: 1.836.075.
Content coolant pipes : (200/18: 3.5 Ltr - 200/30 & 350/18: 5 Ltr - 500/15: 6 Ltr).
Replace the coolant of the engine if necessary (certainly every year).

6.3.12. Recommended lubricants

- Engine
- Pump
- Reduction gearbox
- Coolant engine

6.2.13. Maintenance of the trailer

Lubricate or oil all sliding or jointed parts of the overrun device every 12 months (see photo).
Check regularly for dirt, corrosion or damages.
Check regularly the ball clutch on good operation, potential cleaning and greasing.
Check after the first time the wheel bolts of the trailer and, if necessary, fasten the wheel bolts.
Follow the good torque moments (see also technical data 8.4). Repeat this always when a wheel is loosened,
for example if a tyre is changed (tighten wheel bolts crosswise). White rust on hot-dip galvanized vehicle parts
does not affect safety and can be reduced by means of the following measures:

6.2.14. Maintenance on heat exchanger

Check the heat exchanger regularly on scaling. At lime deposits, the tubes of the heat exchanger need to be
cleaned by means of descaling product. After that, rinsing the heat exchanger thoroughly with (hot) water is
recommended! To clean the heat exchanger thoroughly, you can possibly rely on our service technicians.

6.2.15. Maintenance at expense of technicians

For further maintenance we advise to contact your DiBO distributor concerning a maintenance contract.
The maintenance applies to normal company circumstances.
At heavy circumstances you can communicate this so that can be taken into account.
Extra documents:
Control manual + other manuals of parts
CE- certificat
Electrical plan
Maintenance book
Certificate trailer
Remarks:
It is recommend the preventive maintenance to carry out by a competent DiBO- service technician accord-
ing to this maintenance diagram, to be able to remain use the machine up to maximum and also to be able
to claim the guarantee conditions. To be able to guarantee a good and regular maintenance, we advise the
owner/user at strongest to make an appointment with DiBO against reaching the given up company hours,
concerning a maintenance turn.
JMB-C : REV A
: 1.836.005
: 1.836.042
: 1.836.015
: 1.836.075
- Ensure good ventilation when parking or storing hot-dip galvanized parts.
- After winter operation, wash the hot-dip galvanized surfaces with clean water.
DiBO n.v. 101