Technical Data; General; Machine Statement; General Data - Dibo JMB-C+ Mode D'emploi

Malfunction
Jerky motion or braking/trailer
brakes when towing vehicle
stops accelerating/overrun
device makes noise.
Trailer brakes during reverse
travel.
Hand brake too weak to stop
trailer moving backwards.
Overheating and blocked parts
of the heat exchanger

8. Technical data

8.1. General

In this chapter you find the most important technical data of the range where your machine belongs.

8.1.1. Machine statement

See end of book - chapter 11 - Technical data.

8.2. General data

- Each mounted version has a frame, without protection caps and could be mounted anyplace.
- Each SKID version is carried out as trailer version (= frame with shafts) with protection caps.
- One can obtain two different trailers: - R1300 (single shaft trailer) - K2000 (double shaft trailer)
- Trailers versions are carried out with 386 litres, 617 litres et 780 litres water tank.
- The trailer versions becomes also provide with a 108 litres fuel tank.
- The trailers are also provide with a low and high pressure reel.
- Maximum reactive force of the sprinklers:
- Minimum water pressure (at LP entrance):
- Maximum water pressure (at LP entrance):
- Minimum water temperature
- Maximum water temperature
- Sufficient water supply at drinking water quality (Directive 98/83/EG).
- The vibration intensity through a lance with normal nozzle: exceeding the action value of 2.5 m/s² is unlikely,
the limit value of 5 m/s² on a daily basis will not be exceeded.
- The use of an extra water filter is recommended

8.3. Accessories

1 x User manual
1 x Filter key
1 x Heat resistant gloves (set)
1 x Start key set
1 x Electro box key set
1 x Spray tool(s)
1 x Trailer rear doors set
4 x Trailer side door key set
1 x exhaust hose oil engine
1 x Spare tyre
JMB-C : REV A
Cause
- Shock absorber defective.
- Corrosion and/or lack of wheel
brake lubrication.
- Too much air in the transmission
system.
- Brake pads worn.
Insufficient cleaning, lime blockage
in the passages of heat exchanger
Solution
- Replace shock absorber.
- Remove any dirt and corrosion + lubricate
again.
- Arrange for worn brake shoes to be
replaced.
Braking system adjusted by an expert.
Consult an expert.
Clean sufficient with descaling product.
<60N
200 kPa (2 bar)
300 kPa (3 bar)
1 °C
See technical data
DiBO n.v. 105