Operating Mode - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Instructions for use for the user
4. Hourglass: change to time interval
Change to the
a
which you specify here with the
this specified time has elapsed an acoustic signal sounds (programming see
Point „Operating mode" of these operating instructions).

5. Operating mode

You can activate/deactivate the acoustic signal (produced by the integral buzzer
on the base board):
Change to the time symbol
By simultaneously pressing the
reach the settings menu for programming the acoustic signal. You can now see
the number of the operating mode on the operating unit:
Value Operating mode
0 Soft
1 Hourglass (= standard)
2 Water deficiency
3 Hourglass + water deficiency
Change to the desired operating mode with the keys
selection either with the
symbol (time symbol) with the
and
5
with the
a
5
or .
7 4
7
keys is counted backwards. When
6
key.
7
and keys for at least 3 seconds you
6
Function
No acoustic signal
Hourglass active for 1 sec. after time elapsed
Continuous tone in the event of water de-
ficiency
Both signals active
5
p. 26/42
key. The time (minutes)
and Confirm your
6