Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi page 69

Instructions for use for the user
6. Display: automatic relaying
The operating unit display can be programmed to automatic relaying.
In this mode, the display alternately shows you temperature [°C], time [hours],
brightness [%] and the humidity value [%], insofar as the optionally available
components for climate operation of the Wave.com4 sauna control device are
used (see Point 1.3 of these operating instructions).
Change to the
2
pressing the and
5
menu for the automatic relaying of the display of your operating unit.
Switch on/off the automatic relaying with the
lection either with the
Confirm your selection with the
7. Airing programme/ humidity rectification
Change to the
3
pressing the and
5
menu (the symbol flashes).
3
You can now set the rectification value with the keys
rectification value of "0" is set as standard.
Relay with the
7
airing with heating and ventilator (0 to 2 hours possible).
Relay with the
7
airing without heating, but with ventilator (0 to 30 minutes possible).
Relay with the
7
temperature in a range of between 70 °C and 90 °C.
Confirm your settings with the
symbol (light brightness) with the
keys for at least 3 seconds will take you to the settings
6
or .
7 4
or
7
symbol (humidity symbol) with the
keys for at least 3 seconds will take you to the settings
6
key. The
8 a 3
key. The
8 a
key. The symbol illuminates. You can now set the airing
9
key.
4
7
or
6 5
keys.
4
7
and
5
symbols illuminate. You can now set the
symbols illuminate. You can now set the
p. 27/42
key. DSimulaneously
keys. Confirm your se-
key. Simultaneously
. A temperature
6
EN