Electrical Connection - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 86
Installation instructions, only for experts
If you press the
7
the operating unit is displayed with a preceding "P" (for panel), to distinguish it
from the base unit, e.g. "P14".
When the time has elapsed, the display reverts to stand-by mode.

7. Electrical connection

ATTENTION!
Damage to the unit
● The sauna control unit may only be used for operating and controlling 3 heat-
ing circuits with a maximum heating capacity of 3 kW per heating circuit. The
maximum evaporator capacity totals 3 kW.
Observe the following points when connecting the power to the sauna control unit:
● Installation may only be performed by a qualified electrician or similarly quali-
fied person.
● Work on the sauna control unit may only be performed when the power has
been disconnected.
● There must be a fixed connection for the electrical power supply.
● An all-pole disconnecting device with full cut-off compliant with overvoltage
category III must be fitted on-site.
Please observe that in the event of a guarantee claim, a copy of the bill
from the electrician performing the work must be presented.
key again during this time, the software version number of
p. 31/42
EN

Publicité

Table des Matières
loading

Table des Matières