Screen Display For Arrhythmia Event List; Operation Instructions - Gima 35134 Manuel De L'utilisateur

Operator's Manual for Patient Monitor

4.5 Screen Display for Arrhythmia Event List

Figure 4.13 Arrhythmia Event List Screen

4.5.1 Operation Instructions

The structure is similar to the recall screen. We will cover each function key below.
Start: This button is used to start and end the system Arrhythmia detection. The default is OFF. When the Arrhythmia
is not ON, the "Learn" key is disabled. Press this key and the monitor enters learning stage before detecting
arrhythmia. The "Start" changes to "End". Press it again to end the learning. When "Learn" key change to yellow from
gray, it indicates the learning has finished. When the ARR detection begins after learning, the monitor will
automatically detect the ARR event. If an ARR event is detected, the ECG waveform with corresponding ARR event will
be displayed in the 3 rd trace of waveform, shown in Figure 4.13.
When the monitor get Reset or the patient ID has been changed, the ARR detection needs to be re-learned.
Learn: Because the Arrhythmia detection is based on the pattern of normal ECG waveform, which is built up during
learning stage. When the patient changes, the ARR detection could be incorrect, so re-learning is needed. To get
better result of the learning function, it is recommended to start learning while a segment of good quality ECG
waveform appears during the ECG monitoring.
View: Press this key, and the selected record in the Arrhythmia event list, which is to be reviewed, becomes the green.
Rotate the "Navigation Knob" to choose the record and display the corresponding waveform in the 3 rd trace of
waveform. Press the knob again to exit.
27