While Operating Machine; Battery Meter - Tennant T3 Opérateur Manuel Et Liste Des Piéces

WHILE OPERATING MACHINE

WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
1. Overlap each scrubbing path by 5 cm (2 in).
2. Keep the machine moving to prevent damage to
floor finish.
3. Wipe the squeegee blades with a cloth if blades
leave streaks. Pre-sweep the area to prevent
streaking.
4. Do not operate the machine on inclines that
exceed 5% (3°).
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
5. Pour a recommended foam control solution into
the recovery tank if excessive foam appears.
ATTENTION: Do not allow foam to enter the float
shut-off screen, vacuum motor damage will result.
Foam will not activate the float shut-off screen.
6. Use the double scrubbing method for heavily
soiled areas. First scrub the area with the
squeegee up, let solution set for 3--5 minutes, then
scrub the area a second time with the squeegee
down.
7. Change or rotate pads as needed.
8. Observe the battery meter discharge level (See

BATTERY METER).

9. Observe the solution tank sight gauge for remaining
solution. 10 liters will last approximately 10 minutes
during conventional scrubbing and 20 minutes
during foam scrubbing with the FaST Model.
10. When the solution tank runs dry, empty the
recovery tank before refilling.
11. When leaving the machine unattended, park the
machine on a level surface and remove the key.
12. Perform the Daily Maintenance procedures after
scrubbing (See MACHINE MAINTENANCE).
BATTERY METER
The battery meter displays the charge level of the
batteries. When the batteries are fully charged, all
indicator lights are lit. As the batteries discharge, the
indicator lights will begin to go out from right to left.
To prolong the life of the batteries, do not allow the
indicator lights to go beyond the discharge level as
described below.
NOTE: To prolong the life of the batteries ONLY
recharge the batteries when the machine is used for a
total of 30 minutes or more.
Tennant T3 (08- -05)
Home Find... Go To..
DRIVE MODEL: When the discharge level reaches
the first red light (Figure 22), stop scrubbing and
recharge the batteries. If the last red light begins to
flash, the scrubbing function will shut off automatically.
This protects the batteries from total discharge. Drive
the machine to the charging area and recharge the
batteries immediately.
NOTE: The Drive Model battery meter also displays
machine fault codes. If a fault is detected the LED
bars will flash specific fault codes (See LED FAULT
CODES).
Stop scrubbing and recharge batteries
FIG. 22
BRUSH ASSIST MODEL: When the discharge level
reaches the last yellow light (Figure 23), the light will
begin to flash, stop scrubbing and recharge the
batteries. If the red light appears, the scrubbing
function will shut off automatically. This protects the
batteries from total discharge. Recharge the batteries
immediately.
Stop scrubbing and recharge batteries
FIG. 23
OPERATION
13