Machine Operation; Pre--Operation Checks; Operating The Machine - Tennant T3 Opérateur Manuel Et Liste Des Piéces

NOTE: When filling the solution tank with a bucket,
make sure that the bucket is clean. Do not use the
same bucket for filling and draining the machine.
ATTENTION: For Conventional Scrubbing, only
use recommended cleaning detergents. Machine
damage due to improper detergent usage will void
the manufacturer's warranty.
WARNING: Fire or Explosion Hazard.
Never Use Flammable Liquids.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.

MACHINE OPERATION

FOR SAFETY: Do not operate machine, unless
operator manual is read and understood.
WARNING: Fire Or Explosion Hazard. Never
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
FIRST TIME USE (FaST Model): The FaST system is
protected against freezing during shipment. You must
operate the FaST system for 10 minutes to disperse
the mixture of RV anti--freeze/FaST concentrate
before achieving maximum foam.
PRE- -OPERATION CHECKS
- Sweep and dust-mop the floor.
- Check the battery meter charge level (See
BATTERY METER).
- Check the pad/brush for wear.
- Check the squeegee blades for wear and proper
adjustment.
- Make sure the recovery tank is empty and the
float shut--off screen is installed and clean.
- Check the scrub head skirt for wear.
- Foam scrubbing (FaST Model): Check the
FaST--PAK concentrate level.
- Foam scrubbing (FaST Model): Make sure the
solution tank is filled with only cool clean water, no
detergents.
Tennant T3 (10- -04)
Home Find... Go To..

OPERATING THE MACHINE

1. Turn the main power key switch to the on ( I )
position (Figure 14).
FIG. 14
2. FaST Model: To foam scrub, press the FaST
system switch to the on ( I ) position (Figure 15).
NOTE: When using the FaST model for conventional
scrubbing DO NOT turn the FaST system switch on.
Conventional cleaning detergents/restorers may cause
failure to the FaST injection system. Drain, rinse and
refill solution tank with cool clean water before
operating the FaST system.
FIG. 15
3. Lower the squeegee assembly to floor by lowering
the squeegee lift lever (Figure 16). The vacuum
motor will automatically turn on.
FIG. 16
OPERATION
11