Operating Machine; While Operating; Cleaning The Waste Bins - Tennant S8 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.1 -OPERATING MACHINE

FOR SAFETY: Do not operate machine unless trained and au-
thorized. When using machine, do not pick up liquids or leave
unattended. Before leaving machine remove key and never
allow children to play on or around
To start the machine carry out the following operations:
- Make sure the side brush pos.1 Fig.3 is 0.
- Turn the switch pos.2 Fig.3 to position I. Wait 10 seconds before
operating machine.
- Before operating machine, check the indicator pos.4 Fig.3, to
assess whether the battery is fully charged. If it is not,proceed to
recharge it.
- Pull the traction lever pos.6 Fig.3, to start cleaning.
If necessary, operate lever pos.1 Fig.3, by turning it to I position,
to start the side brush. If you have been using the side brush, at
the end of your work remember to turn it to 0 position. Switch off
the machine and remove the key from the control panel.
An automatic device will prevent you from using the machine be-
yond a certain battery discharge limit.
When this limit is reached, the machine will stop and the battery
must be recharged.

4.2 -WHILE OPERATING

After starting the machine, you are ready to start using the swee-
per. To obtain best results, you should always take certain precau-
tions. These will help you to get the best from your machine and
reduce the risk of damage to a minimum.
In particular:
- FOR SAFETY: When using machine, do not pick up cables,
strings, wires or other similar materials
- When using the machine on light but bulky material (sheets of
paper, leaves, etc.), raise the front part of the machine by pressing
down the handlebar so that the machine can tackle the rubbish.
- Use the dust flap lever to pick up bulky debris
- Operate the filter shaker at the end of your work (see the Panel
filter section).
- Make sure the center brush is correctly adjusted (see the section
on adjusting the center brush).

4.3 -CLEANING THE WASTE BINS

Before carrying out this operation, make sure the machine is
turned off completely.
(*)ATTENTION: WASTE MUST BE DISPOSED OF STRICTLY IN
ACCORDANCE WITH THE LAW.
4.3.1 -Front bin ( fig.4 )
- Lift and turn the two bin locks.
- Grasp the handle/s and remove the bin by pulling it upwards.
- Empty the bin (*).
To put the bin back in place:
- Put the bin back in the machine from the top.
- Turn and lower the two locks.
4.3.2 -Rear bin ( fig.5 )
- Lift and turn the two bin locks.
- Grasp the handle and pull the bin out of the machine.
- Empty the bin (*).
To put the bin back in place:
- Fit the bin back into the machine.
- Turn and press the two locks.
Fig.4
Fig.5
- 9 -

Publicité

Table des Matières
loading

Table des Matières