Installing Fast--Pak (Fast Model); Filling Solution Tank - Tennant T3 Opérateur Manuel Et Liste Des Piéces

OPERATION
INSTALLING FaST- -PAK (FaST Model)
FaST 365 Floor Cleaning Concentrate (#1017015)
ATTENTION: The FaST- -PAK Concentrate Formula
is specifically designed for the FaST system.
NEVER use a substitute, machine damage may
result.
1. Remove the perforated knock-out from the
FaST--PAK carton. Do not remove the bag from
the carton. Pull the hose connector through the
knock--out and remove the orange cap
(Figure 10).
FOR SAFETY: When using machine, always follow
the handling instructions on chemical container.
FIG. 10
2. Lift the recovery tank to access the FaST--PAK
compartment. Connect the supply hose to the
FaST--PAK and place the FaST--PAK carton into
the compartment as shown (Figure 11). Make sure
that the supply hose doesn't get kinked or
pinched.
NOTE: If any dried concentrate is visible on the
supply hose connector or on the FaST- - PAK
connector, soak and clean with warm water.
FIG. 11
3. When the supply hose is not in use, make sure to
connect it to the storage plug (Figure 12). This will
prevent the FaST system from drying out and
clogging up the supply hose.
10
Home Find... Go To..
FIG. 12

FILLING SOLUTION TANK

The machine is equipped with a hose fill--port at the
rear of the machine, and a bucket fill--port located
under the recovery tank (Figure 13). Before accessing
the bucket fill--port make sure that the recovery tank is
empty.
Fill the solution tank to the "40 L MAX" level on the
solution tank sight gauge. When using the bucket
fill--port, stop filling when the level reaches the bottom
edge of the fill--port (Figure 13).
FOR FOAM SCRUBBING (FaST Model) : FILL THE
TANK WITH ONLY CLEAN COOL WATER (<21°C /
70°F). DO NOT use hot water or add any conventional
floor cleaning detergents, FaST system failure may
result.
FOR CONVENTIONAL SCRUBBING: Fill the tank
with hot water, 60°C (140°F) maximum. Pour a
recommended cleaning detergent into the solution
tank according to mixing instructions on the bottle.
FIG. 13
Fill to bottom edge
Tennant T3 (10- -04)