Operating Machine; While Operating; Cleaning The Waste Bins - Tennant S8 Mode D'emploi Et Pièces Détachées

Balayeuse a batterie
Masquer les pouces Voir aussi pour S8:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.1 –OPERATING MACHINE
FOR SAFETY: Do not operate machine unless trained and
authorized. When using machine, do not pick up liquids or leave
unattended. Before leaving machine remove key and never allow
children to play on or around
To start the machine carry out the following operations:
- Make sure the side brush pos.1 Fig.3 is 0 .
- Turn the switch pos.2 Fig.3 to position I . Wait 10 seconds before

operating machine.

- Before operating machine, check the indicator pos.4 Fig.3 , to assess
whether the battery is fully charged. If it is not, proceed to recharge it.
- Pull the traction lever pos.6 Fig.3 , to start cleaning.
If necessary, operate lever pos. Fig.3 ,by turning it to I position , to
start the side brush. If you have been using the side brush, at the end of
your work remember to turn it to 0 position . Switch off the machine
and remove the key from the control panel.
An automatic device will prevent you from using the machine beyond a
certain battery discharged limit.
When this limit is reached, the machine will stop and the battery must
be recharged.

4.2 - WHILE OPERATING

After starting the machine, you are ready to start using the sweeper. To
obtain best results, you should always take certain precautions. These will
help you to get the best from your machine and reduce the risk of damage
to a minimum.
In particular:
- FOR SAFETY: When using machine, do not pick up cables, strings,
wires or other similar materials
- When using the machine on light but bulky material (sheets of paper,
leaves, etc.), raise the front part of the machine by pressing down the
handlebar so that the machine can tackle the rubbish.
- Use the dust flap lever to pick up bulky debris
- Operate the filter shaker at the end of your work (see the Panel filter
section).
- Make sure the center brush is correctly adjusted (see the section on
adjusting the center brush).

4.3 -CLEANING THE WASTE BINS

Before carrying out this operation, make sure the machine is turned off
completely.
(*)ATTENTION:
STRICTLY IN ACCORDANCE WITH THE LAW.
4.3.1 -Front bin ( fig.4 )
- Lift and turn the two bin locks.
- Grasp the handle/s and remove the bin by pulling it upwards.
- Empty the bin (*).
To put the bin back in place:
- Put the bin back in the machine from the top.
- Turn and lower the two locks.
4.3.2 -Rear bin ( fig.5 )
- Lift and turn the two bin locks.
- Grasp the handle and pull the bin out of the machine.
- Empty the bin (*).
To put the bin back in place:
- Fit the bin back into the machine.
- Turn and press the two locks.
8
WASTE
MUST
BE
DISPOSED
Fig. 4
Fig. 5
OF

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

90012139001400

Table des Matières