Machine Installation; Uncrating Machine; Installing Batteries - Tennant T3 Opérateur Manuel Et Liste Des Piéces

MACHINE INSTALLATION

UNCRATING MACHINE

1. Carefully check the shipping crate for signs of
damage. Report damages at once to carrier.
2. Check the contents list. Contact distributor for
missing items.
Contents:
2--12 V Batteries -- Optional
S
24V Battery Charger -- Optional
S
2--Foam Battery Spacers (#630375)
S
Battery Tray (#1012994)
S
38 cm (15 in.) Battery Cable (#130364)
S
4--Battery Cable Rubber Boots
S
1--FaST--PAK 365 Concentrate (#1017015)
S
(FaST Model)
Squeegee Assembly (#9001178)
S
Pad Driver -- Optional
S
Brushes and pads must be purchased separately.
3. To uncrate your machine, remove the shipping
hardware and straps that secure the machine to
the pallet. With assistance, carefully lift the
machine off the pallet.
ATTENTION: Do not roll machine off pallet unless
a ramp is used, machine damage may occur.
ATTENTION: To prevent possible machine
damage, install batteries after removing machine
from shipping pallet.

INSTALLING BATTERIES

WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Hood Open When
Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Battery Specifications:
Two 12 volt deep cycle lead acid batteries.
105 AH battery -- 43cm (17 in) Brush Assist Model
130 AH battery -- 50cm (20 in) Brush Assist Model
155 AH battery -- 50cm (20 in) Drive Model
Maximum battery dimensions: 174 mm ( 8.85 in) W x
380 mm (15 in) L x 284 mm (11.18 in) H.
1. Park the machine on a level surface and remove
the key.
Tennant T3 (01- -07)
Home Find... Go To..
2. Lift the recovery tank to access the battery
compartment (Figure 1).
FIG. 1
3. Carefully install the batteries into the battery
compartment tray and arrange the battery posts
as shown (Figure 2). Insert the two foam spacers
along side the batteries as shown.
ATTENTION: Do not drop the batteries into the
compartment, battery and machine housing
damage may result.
BLACK
RED
2
Brush Assist Model
Drive Model
Foam Spacer
BLACK
RED
2
Foam Spacer
FIG. 2
4. Before connecting the battery cables, make sure
the terminals and posts are clean. Use a post
cleaner and wire brush if necessary.
NOTE: Apply a light coating of non-metallic grease or
protective spray on the cable connections to prevent
battery corrosion.
OPERATION
1
1
7