Draining Solution Tank; Charging Batteries; Battery Charger Specifications - Tennant T3 Opérateur Manuel Et Liste Des Piéces

3. Remove and clean the float shut-off screen
located in the recovery tank (Figure 28).
FIG. 28

DRAINING SOLUTION TANK

1. To drain any remaining water from the solution
tank, pull the solution tank level hose off the hose
fitting as shown (Figure 29).
FIG. 29
2. To rinse out the solution tank, remove the
clean--out cap at the rear of the machine and
spray water, 60°C (140°F) maximum, directly into
the two fill--ports located under the recovery tank
(Figure 30).
FIG. 30
Tennant T3 (10- -04)
Home Find... Go To..
3. Remove and clean the solution tank filter
(Figure 31). Turn the filter counter--clockwise to
remove.
FIG. 31
4. After rinsing out the tank, securely replace the
solution tank filter, clean--out cap, fill--port covers
and hose.

CHARGING BATTERIES

ATTENTION: To prolong the life of the batteries
and to provide optimum machine performance,
ONLY recharge the batteries after a total of 30
minutes of use or more. Do not leave batteries
discharged for lengthy periods.
The following charging instructions are intended for
battery chargers supplied with the machine. Only use
a battery charger with the following specifications to
prevent battery damage.

BATTERY CHARGER SPECIFICATIONS:

S
CHARGER TYPE:
-- FOR LEAD ACID BATTERIES
S
OUTPUT VOLTAGE - 24 VOLTS
S OUTPUT CURRENT - 15 AMPS
S
AUTOMATIC SHUTOFF CIRCUIT
S
FOR DEEP CYCLE BATTERY CHARGING
1. Transport the machine to a well--ventilated area
for charging.
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
2. Park the machine on a level surface and turn the
key off.
OPERATION
15