How The Machine Works; Brush And Pad Information - Tennant T3 Opérateur Manuel Et Liste Des Piéces

OPERATION
5. Using the supplied battery post boots, connect the
cables to the battery posts in numerical order as
labeled (Figure 2), RED TO POSITIVE (+) &
BLACK TO NEGATIVE (--).
6. After installing the batteries, check the battery
meter charge level (Figure 3). Charge batteries if
needed. (See BATTERY METER on page 13 for
further details)
FIG. 3

HOW THE MACHINE WORKS

Conventional Scrubbing:
Water and detergent from the solution tank flow to the
floor through a manually controlled solution valve. The
brush uses the detergent and water solution to scrub
the floor clean. As the machine moves forward, the
squeegee wipes the dirty solution from the floor into
the recovery tank.
Foam Scrubbing (FaST Model):
(FaST--Foam Scrubbing Technology)
Unlike conventional scrubbing, the FaST system
injects the patented FaST--PAK concentrate formula
with a small amount of water and air onto the floor.
The mixture creates a large volume of expanded wet
foam for the brush to scrub the floor clean. As the
machine moves forward, the foam collapses and the
squeegee wipes the dirty solution into the recovery
tank leaving the floor clean, dry and residue free.
FaST, the Safe Scrubbing Alternative
the National Floor Safety Institute (NFSI) for providing
high traction walk--way surfaces.
Using the foam scrubbing application (FaST) can
increase productivity by 30% by reducing the empty/fill
cycle. It will also reduce chemical usage and storage
space. One FaST--PAK can scrub up to 90,000 m
(1 million sq. ft.).
NOTE: The FaST model can also be operated as a
conventional scrubber. However, it's important that you
follow the instructions in this manual to prevent FaST
system failure.
8
, is certified by
t
2
Home Find... Go To..

BRUSH AND PAD INFORMATION

For best results, use the correct brush type for the
cleaning application. The following are recommended
brushes and pads.
Polypropylene Bristle Scrub Brush (Black) --
Part No. 1016765 -- 43 cm (17 in),
Part No. 1016811 -- 50 cm (20 in)
This general purpose polypropylene bristle scrub
brush is used for scrubbing lightly compacted soilage.
This brush works well for maintaining concrete, wood
and grouted tile floors.
Soft Nylon Bristle Scrub Brush (White) - -
Part No. 1016764 -- 43 cm (17 in),
Part No. 1016810 -- 50 cm (20 in)
Recommended for cleaning coated floors without
removing finish. Cleans without scuffing.
Super Abrasive Bristle Scrub Brush (Gray) - -
Part No. 1016763 -- 43 cm (17 in),
Part No. 1016805 -- 50 cm (20 in)
Nylon fiber impregnated with abrasive grit to remove
stains and soilage. Strong action on any surface.
Performs well on buildup, grease, or tire marks.
Polishing Pad (White) - -
Used to maintain highly polished or burnished floors.
Buffing Pad (Red) - -
Used for light duty scrubbing without removing floor
finish.
Scrubbing Pad (Blue) - -
Used for medium to heavy--duty scrubbing. Removes
dirt, spills, and scuffs and leaves surface clean ready
for recoating.
Stripping Pad (Brown) - -
Used for stripping of floor finish to prepare the floor for
recoating.
Heavy Duty Stripping Pad (Black) - -
Used for aggressive stripping of heavy
finishes/sealers, or very heavy duty scrubbing.
Tennant T3 (10- -04)