Tennant T3 Opérateur Manuel Et Liste Des Piéces page 12

OPERATION
4. Lower the scrub head to the floor by stepping on
the scrub head lift pedal as shown (Figure 17).
FIG. 17
5. Pull the activation bail towards you to start
scrubbing (Figure 18). The drive model will
automatically propel forward. To reverse the drive
model, simply push the activation bail forward.
FIG. 18
6. Drive Model: Adjust the speed control knob to a
desired scrubbing speed (Figure 19).
NOTE: 45--60 meters (150--200 ft) per minute is the
recommended scrubbing speed.
FIG. 19
12
Drive Model- -Reverse
Home Find... Go To..
7. For conventional scrubbing, turn the solution flow
control knob to a desired flow rate (Figure 20).
NOTE: FaST Model - - When using the FaST system,
the solution flow control knob is nonfunctional. The
FaST system has a set solution flow rate.
FIG. 20
8. When more brush pressure is needed for heavily
soiled areas simply lift the down pressure lever
(Figure 21).
FIG. 21
9. To stop scrubbing, release the activation bail, raise
the scrub head and the squeegee.
Tennant T3 (10- -04)