Glass Media Installation / Removal - Napoleon Acies Série Manuel D'installation

11.8 glass media installation / removal

WARNING
!
• Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
• Do not change or substitute the glass media material provided with this appliance. If replacing, use only the
replacement glass media available from your local authorized dealer / distributor.
• Glass media over the burner ports will cause fl ame lifting and sooting problems. Adjust as necessary.
• Do not place any media (glass or vermiculite) in or around the pilot opening and/or on the burner ports. This
will interfere with the pilot operation.
Evenly spread the glass media onto the media tray. Ensure no glass media falls into the pilot opening. If this
happens, insert a clean bag into your vacuum cleaner and vacuum out the glass media. Replacement glass can
be purchased from your local dealer / distributor.
note:
Do not use more media than what was supplied with the appliance.
Do not place media directly onto the burner or pilot opening.
Cleaning Glass Media
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
Removing Media
Using a vacuum cleaner, use a clean bag and vacuum out the glass media.
note:
If media trays (optional) are not required, remove and install glass media for best fl ame and LED appearance.
note:
Do not place media directly over peaks (see "fl ame characteristics" section for more information).
Pilot Area
fi nishing
EN
55
W415-2033 / B / 02.04.20