Finishing; Safety Barrier & Glass Door Installation / Removal - Napoleon Ascent Serie Manuel D'installation

fi nishing
10.0 fi nishing
EN
WARNING
!
• Risk of fi re!
• Never obstruct the front opening of the appliance.
• The front of the appliance must be fi nished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specifi ed dimension, as illustrated.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
• Facing and/or fi nishing material must never overhang into the appliance opening.
• The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishing
or other materials must not be located in the opening surrounding the door as this will interfere with the doors
ability to relieve pressure.
10.1 safety barrier & glass door installation / removal
WARNING
!
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with the appliance
and must be installed.
Before the glass door can be removed, the safety screen
must be removed. Lift the safety screen off the four pins,
tilt the top forward and remove from the appliance.
Leave a hand on the glass door during entire door removal. The glass door is
secured to the fi rebox with two spring latches along the top and two along the
bottom. Pull the handles of the latches forward, then lift the latches out from the
door frame to release the top of the door. Repeat the same step for the two bottom
latches. Next, pivot the door forward until the top edge clears the front of the
appliance. Carefully grip the sides of the door lifting it off the appliance.
note:
These spring latches make up the spring relief system for the appliance. Ensure
they open freely and close sealed.
Reverse these steps to re-install the safety screen and door. Ensure safety screen is
installed correctly.
note:
These spring latches may need to be replaced over time. Do not replace with substitute materials. Contact
your local authorized dealer for more information (see "replacement parts" section).
46
W415-2912 / D / 03.25.21
B
A