Safety Barrier Installation / Removal; Anti Condensation Switch; Firebox Glass Door Installation / Removal - Napoleon Acies Série Manuel D'installation

Masquer les pouces Voir aussi pour Acies Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

finishing
EN

11.5 safety barrier installation / removal

To remove the safety barrier from the appliance carefully lift it up and off the shoulder screws.
A.
To replace, hook the safety screen onto the appliance by lifting it up onto the shoulder screws.
B.
Ensure safety barrier is installed correctly.

11.6 anti condensation switch

This appliance has the option to change from an electronic intermittent pilot ignition (IPI) to a standing pilot for cold
climates. The anti condensation control (standing pilot) is located to the left of the control panel. Using your finger,
flip the switch up for standing pilot or down for intermittent pilot ignition.
Turning the ACS switch on will allow the pilot flame to burn continuously. This mode will minimize the
condensation which forms on the inside of the glass when the main burner is first turned on. It will also help the
appliance and vent system stabilize more quickly during the colder months.
During the warmer winter and summer months, the ACS switch can be turned off to minimize fuel consumption.

11.7 firebox glass door installation / removal

WARNING
!
Do not insert fingers in the gap between the door and the door frame or between the spring latches and door,
there is a risk of injury due to the spring mechanism.
FRONT - ACCESS SIDE
Door trim
Remove the safety screen assembly, refer to the "safety screen installation / removal" section for details.
A.
Remove the door trim by carefully lifting it up and off the frame of the glass door.
B.
50
W415-1707 / 07.04.17
Side view
Door frame
L38 Illustrated

Publicité

Chapitres

Table des Matières
loading

Table des Matières