Glass Guard Assembly (Gga-1) Removal / Installation (Lvx Models Only) - Napoleon Luxuria LVX38P2-1 Manuel Du Propriétaire

maintenance
EN
6.3

glass guard assembly (GGA-1) removal / installation (LVX models only)

WARNING
!
• The polystyrene / styrofoam packaging materials may scratch the glass if the GGA-1 is not covered by the
plastic layer.
• Adequate steps must be taken to protect the appliance and Dynamic Heat Control™ (DHC) openings from
dirt, debris and damage during finishing.
• The GGA-1 installation and/or removal will require 2 people.
• The GGA-1 should be preliminarily fitted and adjusted before finish framing and finishing the appliance. It is
much easier to make adjustments with the appliance pre-finishing access panel removed. It is recommended
that the GGA-1 is removed after preliminary adjustment and stored safely in the original packaging whilst
finishing is complete. Take precautions to protect the appliance during finishing.
Rear view of GGA-1
THIS WAY UP
Access side view of appliance
22
W415-2036 / E / 05.10.22
Key Components
• Outer glass
• Horizontal tab
• Napoleon logo
(affixed to
intermediate glass)
• GGA-1 catch
• GGA-1 catch
securing screws
• Intermediate glass
• GGA-1 mount
bracket
Fig. 1
• Latch
• GGA-1 slider bracket
Fig. 2