Pairing/Deleting Accessory; Pairing New Remote Control And Sensor; Deleting Sensors And Remote Controls; Pairing New Wireless Siren - Smanos W020 Manuel D'utilisation

EN

Pairing/Deleting Accessory

The included accessories have been paired with the control panel
by default, if you want to pair new accessories, please follow these
instructions:

Pairing New Remote Control and Sensor

Tap [+] on the accessory interface to send out pairing signal, and
then trigger the accessory by following the illustration.
Important: Please don't trigger the tamper switch of sensor when
pairing, otherwise the system will recognize the sensor as a 24-hour
zone sensor.
15
Press any button on the
remote control
Press the test button
more than twice(Purchase
separately)
Separate the transmitter
and the magnet
When a beep is heard from the control panel means the sensor
is paired successfully. If two beeps are heard, it means the sensor
has already been paired.
Note: To pair other sensors, please refer to the related user manuals.

Deleting Sensors and Remote Controls

Use the supplied reset pin to press the reset button for about
3 seconds, the control panel will beep once to indicate all the
sensors and remote controls have been deleted.

Pairing New Wireless Siren

Wireless siren is sold separately.
1. Siren enters pairing state (please refer to its user manual).
2. Arm or disarm the control panel on App to send out pairing
signal to the siren.
When a beep is heard from the siren means the siren is paired
successfully. If two beeps are heard means the siren has already
been paired.

Deleting Wireless Siren

Press and hold the pair button of the wireless siren, the deletion
is succeeded when one beep is heard from the wireless siren.
EN
16