Stay Mode; Emergency Call; Mute Mode - Smanos WK7000 Mode D'emploi

EN

Stay Mode

Input user code or admin code, and press
indicator flashes once and the keypad beeps once and sends
Mode] command to the control panel.
When the alarm panel receives the signal, the siren will beep once
and the [Stay Mode] indicator will light on, the alarm system enters
stay mode state.
All the sensors in other zones are armed to prevent the intruder
except that the motion detector in Home Mode Zone is disarmed,
so that people can move freely at home.

Emergency Call

If not inputting code for SOS is set, user just holds the
3 seconds, the LED indicator flashes once, the keypad beeps once,
and the control panel alarms immediately.
23
[Stay Mode] key, the LED
[Stay
[SOS] key for
If inputting code for SOS is set, user needs input user code or
admin code before holding the [SOS]
alarm.

Mute Mode

Mute mode means that the LED indicators of control panel flash,
but the siren does not beep, to avoid disturbing the neighborhood.
Input user code or admin code, and hold any key of
[Stay Mode] for 2 seconds, the LED indicator flashes once, the
keypad beeps once and sends corresponding command to the
control panel.
When the alarm panel receives the signal, the LED indicator lights
on or off, but the siren does not beep.
key for 3 seconds to send an
[Arm] [Disarm]
24
EN