General Description - GYS GYSPACK 750 Manuel D'utilisation

Masquer les pouces Voir aussi pour GYSPACK 750:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Translation of the original instructions
Regulations:
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling
• The battery fitted in this device is recyclable. Please proceed ac-
• The battery must be removed from the device before the latter is
• The device must absolutely be disconnected from the power

GENERAL DESCRIPTION

The high performance internal battery allows the GYSPACK 750 to serve 4 functions:
- Test battery
- Instant Start from vehicle equipped with 12V Lead battery (Gel or Liquid electrolyte).
- 12 V DC power supply, to supply light Spot, TV, tools, etc...
- Light
CHARGE THE INTERNAL BATTERY
Before using the device turn the knob to OFF.
Charge the device once bought and after each use with the charger provided.
Do not use another charger than the one provided with the device.
This device is delivered with an automatic charger (for the internal battery), double insulated with a floating system
enabling to keep the internal battery charged to 100% unsupervised.
To charge the internal battery :
• Place the device vertically during charging to avoid acid leaking and damaging the internal battery.
• Connect the charger to a 230V power supply, The green LED lights and the cigarette lighter LED lights red. Connect
the cigarette lighter plug into the side of the device.
• Turn the knob to 12V to start charging. If the knob stays is on OFF or 24V it will not charge.
• The charger LED turns red when the cigarette lighter plug is connected. The charge is in progress.
• The device is charged once this LED turns back to green.
STARTING A VEHICLE
Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information
and a possible inability to restart.
The booster must be stored in a vertical position. Any other storage position should only be temporary.
In order to use the Gyspack 750 as a starter, follow these steps:
Disconnect the Gyspack from the mains. Turn the vehicle ignition key to OFF.
Position the switch «OFF».
When the battery negative terminal is connected to the vehicle chassis:
-
10
-
facility. Do not dispose of in domestic waste.
cording to the applicable recycling regulations.
discarded.
supply network before removing the battery.
Connect the red clamp to the positive terminal of the battery.
Connect the black clamp to the vehicle chassis, ensure it is not close to fuel lines and the battery.
GYSPACK 750
EN

Publicité

Table des Matières
loading

Table des Matières