General Description - GYS GYSCAP 680 E Manuel D'utilisation

GENERAL DESCRIPTION

Intended for vehicles equipped with a 12V battery, this self-contained starter is equipped with supercapacitors and uses
the battery voltage of a running vehicle to recharge and start the engine within seconds of a failed vehicle.
The GYSCAP 680E operates with five high-performance supercapacitors for a total capacity of 680 Farads.
GYSCAP 680E STATE OF CHARGE
Press the Power button.
The status of the internal capacity of the GYSCAP 680E is displayed.
The digital display shows only one bar: The capacity of the GYSCAP 680E is insufficient.
Refer to the paragraph «recharging the GYSCAP 680E».
The digital display shows four bars: The GYSCAP 680E is not fully charged, but it is still possible to
start a vehicle.
However, it is recommended to recharge the GYSCAP 680E by referring to the paragraph «recharging
the GYSCAP 680E».
The digital display shows six bars: The GYSCAP 680E is fully loaded, so the starting capacity is opti-
mal.
STATE OF CHARGE OF THE BATTERY TO BE STARTED
The GYSCAP 680E displays, via its digital display, the vehicle battery voltage or the alternator voltage if the vehicle is
in operation.
Connect the clamps of the GYSCAP 680E to the battery of a vehicle to be serviced, respecting the
polarity.
Press the Power button.
The voltage will vary depending on the condition of the vehicle.
If the voltage of the supercapacitors is lower than the voltage at the end of the clamps,
the GYSCAP 680E will recharge its supercapacitors up to 14 V see «Recharging the GYS-
CAP 680E».
RECHARGE OF GYSCAP 680E
The GYSCAP 680E recharges in a few seconds by connecting directly to a running 12 Volt battery vehicle.
The voltage of the supercapacitors will be at a maximum of 14 V or the maximum voltage that can
be supplied by the alternator.
If the alternator voltage is lower than 14 V, the GYSCAP 680E will not be 100% recharged.
GYSCAP 680E
EN
11