Translation of the original instructions
BATTERY REPLACEMENT
2
1
Product
Battery
GYSPACK 750
6-SPB-25
To replace the battery :
•
The booster must be disconnected form the power supply.
•
First the back panel must be unscrewed (19 screws) and removed.
Once the back panel is removed, the battery front appears (cf illustration). Remove the positioning belt 1 .
•
The battery is connected to the GYSPACK at two points : at the - terminal 3 and at the + terminal 2 . To
•
remove the battery, remove the 2 screws that enable the connection between the battery and the GYSPACK at
the terminals + and -.
When putting a new battery, make sure to observe the polarities of both the battery and the
GYSPACK 750. Terminal - on the left, terminal + on the right (cf illustration). Put the 2 screws
and washers back, tighten the nuts (recommended torque wrench 4 N.m).
•
Place the booster's backpanel screws back on.
GYSPACK 750
Type
Voltage (V)
Lead- acid battery
12
Dimensions
Capacity (Ah)
(cm)
26
36 x 20 x 43
EN
3
Battery ref
53140
13