General Description - GYS GYSFLASH 18.12 PL-E Manuel D'utilisation

Translation of the original instructions

GENERAL DESCRIPTION

The Gysflash 18.12 PL-E charger is an on-board charger designed for recharging utility batteries found in recreational
vehicles (camper vans, caravans...) and pleasure boating. It is ideal for recharging most lead (Gel, AGM) and Lithium
Iron Phosphate (LFP / LiFePO4) batteries.
This charger is perfectly suited for charging and maintenance of:
- 12 V GEL/AGM lead batteries (6 cells in series) from 36 Ah to 270 Ah.
- LFP batteries 12V (4 elements in series) from 18 Ah to 270 Ah.
CONNECTIONS & WIRING
1
1 2 3
A
L N
1 2
B
S
▪ Crimp the appropriate wiring sleeves 1 for the cross-section of each cable.
▪ Screw the sleeves onto the connector following the connection diagrams for connectors A and B (above).
▪ Clip the connectors into their sockets on the board.
▪ Pass the cables through the rubber cable glands 2 and plug them into the sheet metal.
▪ Attach the flanges 3 in such a way that the wired parts inside the housing are never under tension
(screws M3x20 - TORX 10).
GYSFLASH 18.12 PL-E
A
3
Connections
230~ MAINS CONNECTION
1. LIVE
2. NEUTRAL
4
3. Not Connected
4. EARTH
Order No. Connector Würth Electronik
691344510004
12 V BATTERY CONNECTION
1. SIGNAL mains presence (+12/50mA)
2. NEGATIVE CONNECTION -12 V
3
3. POSITIVE CONNECTION +12 V
Order No. Connector Würth Electronik
691344510003
B
3
2
1
Wiring
Type Section
mini :
3G0.75 mm²
H05RN-F
or equivalent
maxi :
3G2.5 mm²
Battery (2/3)
2.5 mm²
AWG14
H01V-K
or equivalent
Signal (1)
maxi 2.5 mm²
EN
or
9