GYS GYSPACK 750 Manuel D'utilisation page 9

Translation of the original instructions
• Protect the electrical contacts of the battery against short-circuiting.
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse the
affected part of the body with plenty of water and seek immediate
medical assistance.
Connection / disconnection
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
• After the charging process, disconnect the battery charger from
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
Connection:
• Class II device (charger booster)
• Class III device (booster)
• This machine is fuse-protected
• Connection to the mains must be made according to the natio-
nal installation regulations.
Maintenance:
• If the charging / power supply cable is damaged, the product
must be disposed.
• The power supply cable cannot be replaced. If the cable is
damaged,the device should not be used.
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• Regularly take off the cover and remove dust with an air gun. Take
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
GYSPACK 750
EN
9